Lysander update

For own design models
Post Reply
David Cowley

Lysander update

Post by David Cowley » Wed Oct 09, 2013 1:56 pm

Now I finished working on the mowers etc. I have started again on the building of the Lysander, hope you find the work interesting.
DSC00007.JPG
The machined ring at the front of the engine is so I can align the cowl, because the engine has side and down thust and I wanted the prop. in the centre of the cowl.
not shown on any of the images is the fus servo installation which took me some time to get right
DSC00007.JPG (60.7 KiB) Viewed 3861 times
Attachments
DSC00010.JPG
This image shows the amount of work I have done on the Wings, almost ready for covering.
DSC00010.JPG (61.45 KiB) Viewed 3861 times
DSC00009.JPG
This shows the cowl removed and the amount of work I have done inside the engine bay including making a aluminium engine mount
DSC00009.JPG (59.83 KiB) Viewed 3861 times
DSC00008.JPG
Engine cowl showing exhaust, I was going to try and get it inside the cowl but this proved to be very difficult
DSC00008.JPG (59.73 KiB) Viewed 3861 times

Colin
Site Admin
Posts: 116
Joined: Mon Dec 17, 2012 4:45 pm

Re: Lysander update

Post by Colin » Thu Nov 07, 2013 9:02 am

Looking good Dave!

Post Reply