Veron Tiger Moth

Site Admin
Posts: 139
Joined: Mon Dec 17, 2012 4:45 pm

Re: Veron Tiger Moth

Post by Colin » Tue Dec 22, 2020 4:09 pm

Well no updates for a while for various reasons, but there has been progress, focussing on getting the control surfaces fitted and the linkages put in place.
The original kit called for pushrods using 1/4" sq balsa, but I decided I wanted to emulate the full size with closed loop external cables...

Full size run.jpg
Full size run.jpg (170.95 KiB) Viewed 219 times
So these are now installed and seem to work OK - final fettling and adjustment will be done once the receiver is in place. Here's a view ...

Moth control runs.jpg
Moth control runs.jpg (220.56 KiB) Viewed 219 times
The rudder cables run from the rudder bar via the fuselage guide to the rudder. At the moment the bar is ply with the cable holes strengthened with CA. If this shows wear then I will swap to fibreglass ...
Rudder bar.jpg
Rudder bar.jpg (104.65 KiB) Viewed 219 times

At the rear the elevator cables exit mid fuselage ...
Rear control runs.jpg
Rear control runs.jpg (145.8 KiB) Viewed 219 times

Now onto the motor installation ...

Post Reply